IKEv2 CP and EAP support

From Libreswan
Revision as of 00:24, 26 September 2014 by Antony (talk | contribs) (Created page with "CP without EAP. This rather straight forward. But is it used? Useful? Does StrongSWAN support it? Design challenge pose to support EAP: AUTH exchange has [CP] , TSi, TSr...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

CP without EAP.

This rather straight forward. But is it used? Useful? Does StrongSWAN support it?

Design challenge pose to support EAP:

AUTH exchange has [CP] , TSi, TSr. When a receiver get these it reply with EAP and goes off to EAP authentican. However, it must hang on to [CP], TSi, TSr. And after the authentication respond to it. After EAP is complete the initiator does not send TSi and TSr again.

http://tools.ietf.org/html/rfc5996#section-2.15 vs http://tools.ietf.org/html/rfc5996#section-2.19


WPA Supplicant source code has ikev2 has eap_server_ikev2.c what is that?

Retrieved from "https://libreswan.org/wiki/index.php?title=IKEv2_CP_and_EAP_support&oldid=20325"