Subnet to subnet VPN with PSK: Difference between revisions
Tuomo Soini (talk | contribs) No edit summary |
Tuomo Soini (talk | contribs) No edit summary |
||
| Line 1: | Line 1: | ||
Building a tunnel between two endpoints for multiple subnets with PSK authentication is pretty simialar to a [[ | Building a tunnel between two endpoints for multiple subnets with PSK authentication is pretty simialar to a [[ host to host VPN with PSK ]] tunnel. We used the also= keyword to avoid adding the same information into each connection. | ||
<pre> | <pre> | ||
Revision as of 11:21, 4 September 2014
Building a tunnel between two endpoints for multiple subnets with PSK authentication is pretty simialar to a host to host VPN with PSK tunnel. We used the also= keyword to avoid adding the same information into each connection.
# /etc/ipsec.conf
config setup
protostack=netkey
conn mysubnet
also=mytunnel
leftsubnet=192.0.1.0/24
rightsubnet=192.0.2.0/24
auto=start
conn mysubnet6
also=mytunnel
connaddrfamily=ipv6
leftsubnet=2001:db8:0:1::/64
rightsubnet=2001:db8:0:2::/64
auto=start
conn mytunnel
left=192.1.2.23
right=192.1.2.45
authby=secret
# use auto=start when done testing the tunnel
To test the tunnel on "west":
# ping -n -c 4 -I 192.0.1.254 192.0.2.254 PING 192.0.2.254 (192.0.2.254) from 192.0.1.254 : 56(84) bytes of data. 64 bytes from 192.0.2.254: icmp_seq=1 ttl=64 time=0.XXX ms 64 bytes from 192.0.2.254: icmp_seq=2 ttl=64 time=0.XXX ms 64 bytes from 192.0.2.254: icmp_seq=3 ttl=64 time=0.XXX ms 64 bytes from 192.0.2.254: icmp_seq=4 ttl=64 time=0.XXX ms --- 192.0.2.254 ping statistics --- 4 packets transmitted, 4 received, 0% packet loss, time XXXX rtt min/avg/max/mdev = 0.XXX/0.XXX/0.XXX/0.XXX ms
The reason why you need to specify the source address for the ping command is that Linux will always pick the "nearest IP" automatically. Since the nearest IP would be 192.1.2.23, and that IP is not part of the 192.0.2.0/24 subnet, the ping would go out unencrypted. If you want all communication between the gateways themselves to be encrypted, and it is okay that they will talk to each other on their internal IP addresses, you can use the leftsourceip= and rightsourceip= options:
conn mysubnet
also=mytunnel
leftsubnet=192.0.1.0/24
leftsourceip=192.0.1.254
rightsubnet=192.0.2.0/24
rightsourceip-192.0.2.254
auto=start
libreswan will than add a route to the system for the remote subnet using the "src <ipaddress>" parameter to accomplish this.
Alternatively, you could add IPsec tunnels for the host-host connection, but you would also need to add tunnels for the host-subnet and subnet-host connections. This is a little cumbersome, so usually people just use the sourceip= options.